37
Building construction; repair; installation services
services related to system verification of industrial sensing, monitoring, instrumentation and measurement devices, including flowmeters, clamp-on flowmeters, flow rate monitors, mass flow rate meters, volumetric flow rate meters, fluid flow monitors, pressure sensors, arrays of pressure sensors, strain sensors, temperature sensors, acoustic sensors, leak detectors, consistency meters, density meters, steam meters, steam wetness meters, steam quality meters, steam enthalpy meters, air/fuel ratio meters, gas/fuel ratio meters, pulverized fuel meters, gas flowmeters, liquid flowmeters, gas-volume fraction meters, and speed-of-sound monitors, composition monitoring equipment, including consistency meters, water/cut meters, density meters, mass flow meters, total air meters; computers, processors and controllers for monitoring, processing, and analysis of data; computer software for installing, performing diagnostic tests on, setting operating parameters in, and repairing industrial sensing, monitoring, instrumentation and measurement devices; computer software for receiving and transferring data from industrial sensing, monitoring, instrumentation and measurement devices for analysis in other computer software; computer software for updating software in industrial sensing, monitoring, instrumentation and measurement devices; computer firmware for use in industrial sensing, monitoring, instrumentation and measurement devices; digital memory storage devices; and electrical plugs; namely, providing remote system verification that includes receiving electronic data downloaded from the industrial sensing, monitoring, instrumentation and measurement devices to a proprietary website, the electronic data including electronic diagnostic data containing information about the operation of the industrial sensing, monitoring, instrumentation and measurement devices; analyzing the electronic data, including analyzing the electronic data either to ensure that critical measurement points are operating within specification, to compare a transmitter configuration to an initial installation, to evaluate a transmitter optimization, to trend a sensor/pipe contact, to evaluate sensor health, to check system voltages against allowed tolerances, to review an on-board health check status, to analyze data for predictive maintenance recommendations, or some combination thereof, as well as remotely analyzing the electronic data by a technician; and issuing a verification report containing information about the analysis, including information about the comparison of the transmitter configuration to the initial installation, the evaluation of the transmitter optimization, the trending of the sensor/pipe contact, the evaluation of the sensor health, the checking of the system voltages against the allowed tolerances, the review of the on-board health check status, the analysis of all the data for any predictive maintenance recommendations, or some combination thereof; as well as also providing on-site system verification, including visits by a technician to perform at least some of the aforementioned analysis